June 25

DPF mount for PatchAdams
Posted on June 25th, 2008 at 6:25 PM by slm4996

Patch, here is my horrible drawing of my idea. Basically you take two peices of wood with a hinge pin holding them together for each side. the top will be fixed in place and the bottom will fit into a series of grooves on the wall bracket. the higher the groove the more tilt the frame has. done right this will only add about .5-1 inch of depth to the display. This isn’t ideal as it doesn’t allow for any side to side tilt but it should work well for up and down.

Sorry for the horrible drawing, I don’t have anything but Gimp installed here at work.

One Response to “ DPF mount for PatchAdams ”

  • patchadams says:
    June 27, 2008 at 12:15 am

    Thanks,

    This is similar to an idea i had the other day, where there is a piece of wood fixed to the wall and the dpf is hinged at the bottom and you can tilt it as needed downwards. I’ll look around at possible materials. Your idea is nice and simple and could work quite well. I’ll look at both of them some more and see what happens.

    thanks again

    Reply

Leave a Reply